ANTIQUE-RADIO-LAB
Welcome, please log in to participate in this (your) forum, ***by logging in Your ZIP CODE is REQUIRED before you will be approved****, and when LOGGING IN you agree to abide by the rules of this forum.

NOTE: Until you make your FIRST Login and post, you cannot PM a Member.
ANTIQUE-RADIO-LAB

Antique Radio Forum for Collectors antique-radio-lab.forumotion.com


how tu use sweep signal generator EP-655-b

ANTIQUE-RADIO-LAB :: Radio Repair Bench :: Test Equipment

Go down

how tu use sweep signal generator EP-655-b Empty Re: how tu use sweep signal generator EP-655-b

Post by Guest April 23rd 2020, 9:58 pm

Maybe you are not getting any actual output from the sweep generator. If your oscilloscope and scope probe is in good shape then the sweep generator likely has a fault in it. You will have to check it out and make repairs. Good luck.
73, Rod  WB6FBF

Guest
Guest


Back to top Go down

how tu use sweep signal generator EP-655-b Empty how tu use sweep signal generator EP-655-b

Post by Guest April 16th 2020, 11:21 am

I have a sweep marker genarator EP-655-B when I connect its RF output with the 10: 1 probe of the oscilloscope I see a sine wave on my oscilloscope and when I turn the potentiometer frequency marker the frequency changes on the display of the generator while the wave does not change on the oscilloscope my question is what this behavior is right or there is a problem in the generator and how I can use this generator in the radios and tv sets; thanks

Guest
Guest


Back to top Go down

Back to top

- Similar topics

ANTIQUE-RADIO-LAB :: Radio Repair Bench :: Test Equipment

 
Permissions in this forum:
You cannot reply to topics in this forum